7.2.1.7 Packet Tracer – Configuring Named Standard IPv4 ACLs Instructions Answers

Packet Tracer – Configuring Named IPv4 Standard ACLs

Addressing Table

Objectives

Part 1: Configure and Apply a Named Standard ACL
Part 2: Verify the ACL Implementation

 

Background / Scenario

The senior network administrator has tasked you to create a standard named ACL to prevent access to a file server. All clients from one network and one specific workstation from a different network should be denied access.

Part 1: Configure and Apply a Named Standard ACL

Step 1: Verify connectivity before the ACL is configured and applied.

All three workstations should be able to ping both the Web Server and File Server.

Step 2: Configure a named standard ACL.

Configure the following named ACL on R1.

R1(config)# ip access-list standard File_Server_Restrictions

R1(config-std-nacl)# permit host 192.168.20.4

R1(config-std-nacl)# deny any

Note: For scoring purposes, the ACL name is case-sensitive.

Step 3: Apply the named ACL.

a. Apply the ACL outbound on the interface Fast Ethernet 0/1.

R1(config-if)# ip access-group File_Server_Restrictions out

b. Save the configuration.

Part 2: Verify the ACL Implementation

Step 1: Verify the ACL configuration and application to the interface.

Use the show access-lists command to verify the ACL configuration. Use the show run or show ip interface fastethernet 0/1 command to verify that the ACL is applied correctly to the interface.

Step 2: Verify that the ACL is working properly.

All three workstations should be able to ping the Web Server, but only PC1 should be able to ping the File Server.

 

[sociallocker id=”8545″]

[wpdm_package id=’9500′]

[wpdm_package id=’9499′]

[/sociallocker]

Leave a Reply